|
· Fiber Optic Transmitter/Receiver & Repeater Board |
|
|
|
|
|
Specs |
Channels: 2 transmit channels, 2 receive channels. Optical: To be used with 1000 micron plastic fiber optic cable. Fiber distance should be limited to 40 meters unless special low-loss fiber is used. These units can be used as repeaters to go greater distances. Electrical: Electrical signals to be transmitted are TTL compatible. Received signals are converted to TTL and can drive loads of 50 ohms maximum. Power Req.: 5-24Vdc. If +5 Vdc is used for power, the voltage regulator is not needed. Note: Voltages above +5 Vdc will cause a fair amount of heating on the voltage regulator. I/O Interface: 10 terminal plug-in terminal strip for all signals and power. Physical: Approximately 2.5" X 2.75". Mounting: Can be mounted with stand-offs or DIN-rail custom circuit module. |
|
Cost |
P/N 0000-002, $195. Price is dependent on quantity and is subject to change at any time without notification. |
|
VISA, MasterCard, and AMEX accepted. Designed and Created by VI Control Systems Ltd. |
|
